Skip to content
Mammoth 3D Print Settings & Recommendations

Mammoth 3D Print Settings & Recommendations

DISCLAIMER:
Each resin and printer combination is unique, you will have to test and find out what works best for you, these are recommendations for a starting point.

IN THIS DOCUMENT
# 3D Printing Settings # Links & Resources

ALL of Mammoth Factory STL files come in 3 Versions:

  • Pre-Supported “.STL” Files (Basic, Plug & Print)
  • Pre-Supported “.LYS” Files (Experienced, Editable Supports)
  • UN-Supported “.STL” Files (Advanced, Do-it-yourself)

 

3D PRINTING SETTINGS

 

# PRINTER AND RESIN
All of our 3D test printing is done with: Elegoo Mars 3 3D Printer & Vulkan 8K Resin

 

# BUILD PLATE / SIZE
All designs are cut to fit a Elegoo Mars Build Plate (68mm x 120.8mm x 150mm)

#THE NUMBERS
Here are our recommended settings when using the above printer-resin combo:


 

PRO TIPS

 

WARM WATER (easy supports removal)
Soak the model in warm water for a few seconds before removing the supports with clippers. Also you can use a pair of pointed tweezers to remove hard to reach supports.

 

PRINTER CALIBRATION TESTS

We recommend Amerilabs Town Test & the Cones of Calibration by Tableflip Foundry.

 

SLICER SOFTWARE - LYCHEE

Mammoth Factory is a proud Lychee Ambassador. We use Lychee Slicer to both Support and Print our miniature files. You can get Lychee Slicer here

 

OFFICIAL COMMON RESIN SETTINGS

Official Elegoo Resin, Anycubic Resin, Phrozen Resin, Siraya Tech Resin

    2 comments

    I like the thought of including your recommended print settings for your models, based on what printer you have. I wish other designers would do the same.

    Brian

    Can’t wait to paint.

    Anthony Drago
    Leave your thought here

    Please note, comments need to be approved before they are published.

    Drawer Title
    Similar Products